Helmholz PROFINET/CANopen Slave gateway

Easy and straightforward connection of CAN devices to PROFINET
Produktnummer: 700-672-PNC01

The PN/CAN gateway "CANopen Slave" enables the coupling of machines with CANopen bus to machines with PROFINET network and represents a freely configurable full CANopen Slave Device at the CAN bus.

On the PROFINET network the PN/CAN gateway "CANopen Slave" is a PROFINET I/O device and supports transfer rates up to 100 Mbit full duplex. The data of the CANopen SDOs are transparently and freely configurably inserted into the PROFINET network and can thus be read or written directly in the PLC. The PN/CAN gateway is integrated into the hardware configurator of the PROFINET controller with a GSDML file, and all values of the CANopen slave are available as IO information. Special handling blocks are not necessary.

An EDS or DCF file is used to permanently load a plant-specific CANopen device configuration into the device.

The features MRP (media redundancy) as well as extensive diagnostic functions and an interface for online diagnostics complete the performance features of the PN/CAN gateway.

The gateway supports CANopen network management, nodeguarding/heartbeat, emergencies and SDO accesses on the CAN bus. Up to 16 RX- and Tx-PDOs can be parameterized.
It is also possible to parameterize the CANopen device including PDO mapping via the CAN bus and to send customer specific emergency messages.

  • CANopen Slave Device according to CANopen protocol DSP 301
  • Up to 16 TPDOs / 16 RPDOs
  • Up to 1420 bytes input and 1420 bytes output data on PROFINET
  • Up to 1 Mbit/s CAN bit rate
  • CANopen NMT, Heartbeat, Nodeguarding, Emergency
  • PROFINET Conformance Class C
  • PROFINET media redundancy (MRP client)
  • Configuration via EDS/DCF file and GSDML file
  • No handling blocks necessary
  • USB device interface for loading the configuration, online diagnosis and firmware update
General information
Order number 700-672-PNC01
Scope of delivery PN/CAN gateway
Dimensions (DxWxH) 35 x 84 x 76 mm
Weight Approx. 160 g
PROFINET interface
Number 1
Protocol PROFINET IO as defined in IEC 61158-6-10
Physical layer Ethernet
Transmission rate 100 Mbps
I/O image size 1420 bytes of input / output data
Connection RJ45 socket
Features Media Redundancy Protocol (MRP), automatic addressing / topology detection (LLDP, DCP)
CAN interface
Number 1
Type ISO/DIN 11898-2 CAN High-speed physical layer
Transmission rate 50, 100, 125, 250, 500, 800, 1000 kbps
Protocol CANopen® master as defined in DSP301 V4.2
Connection 9-pin D-sub male connector
TPDOs 16 per slave
RPDOs 16 per slave
Features Heartbeat, Nodeguarding, Emergencies
USB interface
Protocol Full-speed USB 2.0 device
Connection Mini-USB
Isolation voltage 1.5 kV
Electrical isolation Yes